Enabling/Disabling a SAID Node

This section describes how to enable or disable a system of active immunization and diagnosis (SAID) node using commands.


The diagnosis and recovery durations of a single SAID node must not exceed 10 and 30 minutes, respectively. If either duration is exceeded, the SAID node is disabled by default. When a SAID node is processing a large number of services, the processing efficiency of other SAID nodes may be reduced because of performance insufficiency. To guarantee the processing efficiency, you can run the set said-node command to disable this node.

If the node is not in the detecting state after being disabled, it automatically returns to the detecting state upon completion of the operation in the current phase. When the next SAID task is started to perform detection, the system detects that the SAID node is disabled and therefore skips it.


  1. Run system-view

    The system view is displayed.

  2. Run set said-node { all | said-name [ slot slot-id ] } disable

    The SAID node is disabled.

    In VS mode, this command is supported only by the admin VS.

Checking the Configurations

After enabling/disabling a SAID node, check the configurations.

Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >